RC Car Silv Glit. 150ml

Airbrush specifications

    Dilute with aceton

Applications

RC Car Colours have been specially developed for the painting of Polycarbonate bodies. The special solvent used etches the surface, allowing the paint to bond permanently with the polycarbonate.
Before you begin ... Remove any dirt particles from the surface to be painted


Polycarbonate bodies

Cut out the body and sand the cut edges. Many bodies have a transparent protective foil on the outside. Do not remove this protective foil until the paints has dried! Mask all areas that are not to be painted, by using masking film or masking tape. First paint the dark and then the light colours so as to prevent the dark colours from shining through the lighter ones. Always check to make sure that the surfaces are dry and free of dust before painting!
For best results

    Before use, shake the can vigorously for approx. 2 min. until you hear the mixing ball rattling.
    Spray at a distance of approx. 20 to 30 cm. While spraying make even cross movements with the can.
    The covering capacity of RC Car Colours varies slightly from one colour to the next. Always spray one very light coat at a time to avoid bleeding. The final result is obtained after 2 to 3 coats. Wait approx. 5 min. before applying the next coat. Never spray just one heavy coat!
    Allow the paint to dry for 5 minutes before removing the masking film and applying the next coat.
    After use, turn the can upside down and spray for 2 sec. until the nozzle is empty.

Special instructions for glitter colours

Glitter colours are structured so that they must be sprayed first onto the body. Special care should be taken with these colours to apply very light coats only! These colours are only effect particles that are sprayed onto the body. These colours do not cover! Allow the applied glitter particles to dry for approx. 10 min. before covering them with a base colour.