RR Pacer BOX DAMAGED

The original is a 4-seater light aircraft that was built in the 1950s in the United States. It had a wingspan of about 9 meters and was built with a steel tube fuselage with fabric covered

aluminum wings. The engines were rated between 125-180 horse-power.

Our PACER is made of Elapor® a durable lightweight foam. The assembly is done within a few minutes, without the use of glue. The wing has a foamed-in fiberglass tube as a spar, which provides a lot of strength at a low weight.

The engine mount, landing gear and wing mounts in the fuselage are injection molded from tough plastic and glued in place. The landing gear consists of a white painted aluminum yoke with two large sponge rubber wheels (bushwheels).

Reliable electronic components are also pre-installed in the PACER. These include the four digital servos that are responsible for the control, the powerful brushless motor and the associated 20A controller. The components have been optimally adapted to the model.
With the recommended battery, the drive has a long runtime and you thus a lot of flying fun.

The PACER has absolutely uncritical flight characteristics that will not overwhelm even a beginner. It also gives advanced pilots a lot of pleasure, it is the predestined after-work model.
Thanks to the robust landing gear and the soft wheels, take-off and landing is possible on almost any surface. It can therefore also be used for training young pilots. Besides the super flight characteristics, it also has a great  appearance, especially in the air.

• Piper PA 20 Pacer-inspired design
• Made of lightweight, robust ELAPOR foam
• Quick assembly without glue
• Alaskan Bush' type landing gear
• Pre-installed electronics
• Flying experience for all

• Wingspan: 1150mm
• Lenght over all: 870mm
• Flight weight: 900gr
• RC Function: Aileron, elevator, rudder, motor
• propeller 10x4.7

• multiplex receiver RX-5 M-Link ref 55817
• radio 5+ channel compatible with receiver
• battery ROXXY Evo LiPo 3-2200m 20c ref 1-02593
• compatible charger

• Almost completely built Elapor model
• Built in drive motor Roxxy BL C27-32-1000kv
• Built in controler multicont BL20
• Propeller 10x4.7
• (4) servos MS-12014 digi
• ready decorated
• manual